|
.19” 5086 grade aluminum hull and
deck plate (.25 bottom plate 28' boats)
.19” 5086 grade aluminum lateral
and long framing
.16” 5052 cabin sides (.125" cabin top)
.50” aluminum keel, aluminum bow
stem and bow eye
Aluminum (1/2 pipe) welded rub
rail at gunwale and mid-side rub-rail
Bow railing 1” dia. heavy duty
stainless steel
Anchor bow roller assembly, 22”
stainless steel bow roller
Rear deck railing 1" aluminum Pipe rail welded to aluminum deck coaming
Deck fills, fuel, water, waste,
color coded, fiberglass/nylon
(9) 7” aluminum cleats for
lines/fenders (4 ea side, one in center of bow)
Navigation lighting, horn, all
USCG approved
Slip resistant rear deck
low-profile
21”x21” cuddy escape/vent hatch
Self-
bailing rear deck, with removable rear seat/motor well cover
(5) deck
general stowage compartments with latched hatches
Windows-1/4”
glass with anodized aluminum frames, (3) with slides, (2) with screens
2)
cuddy port windows 10” round rubber frame
| Power - Propulsion - controls |
Single-lever type side mounted
shift/throttle control with keyed start,
Installed by builder to suit Owner's Outboard Motor
Motor Gauges, builder installed to suit Owners Outboard Motor
Manual-hydraulic motor steering
system, 16”ss helm wheel, with stand-up space in front of helm
(2) 30 gallon baffled aluminum
fuel tanks (1) port and (1) starboard
Manual fuel tank selector switch and
fuel/water filter
6’-4” long
cuddy V-berth with deluxe cushions for two adults, with storage below, 2
switched LED lights
Interior Side
material - 1/8” acrylic or poly covered with nylon hull liner cloth to retard
condensation
Cabin ceiling - washable 1/8” rigid acrylic or poly, with 1.5” insulation above, and (6) LED
switched lights
Dinette/settee berth (two adults) 6’4” long with (2) flip-back deluxe
bench seats and cushions by Bentley
(1) berth space
6’4” (under dinette) or use for stowage
Dometic 700 series toilet/holding tank combination pressure flush, privacy door and folding
privacy top
Plastic
laminate plywood galley counter with SS sink, faucets, cold water pressure system,
demand pump
Floors,
counters, helm structure, ½” and 5/8” HPL over marine grade plywood w/laminate both
sides
Table top,
counter top, HDP plywood with laminate face wood trim, with deluxe secure ss
table support
All drawers with ss roller slides, all doors and drawers with deluxe locking pulls
Deluxe helm seat with adjustable forward/back slide, flip-up arm rests, by Bentley
Helm wheel 16” SS w/stand-up space in front
(2) 15 gallon high density polyethylene water tanks with valves located in center of cabin
(3)
water-tight compartments (below floor) each w/bilge pump, at cabin front and
rear
Rear
cabin canvas drop curtain with vinyl windows and roll-up zippered door by Bentley
(2)Electric windshield
wipers with pantographic arms
Main battery-BEP 3 switch battery control cluster with VSR (voltage control relay) to protect battery charge
(1) marine group 27 start battery,
(1) marine group 27 house battery
(1) 12V 60 amp main circuit
breaker
Main panel (6) gang breaker panel
Various sub panels, with fuses for other various power accessories
| 
